Limited Lifetime Warranty

We warranty that our Reconstructed Surfaces products will not will not  peel, separate or delaminate from its properly installed and prepared, vertical or horizontal, interior or exterior surface for lifetime of the original purchaser.

Reconstructed Surfaces warrants that all products will be free from defects under these conditions. Replacement is limited to original cost of materials or replacement, at the choice of Reconstructed Surfaces (excluding shipping, taxes, and/or tariffs). Reconstructed Surfaces sole responsibility under this warranty shall be the cost of replacement materials to fix or repair the failed areas only. A representative or original factory trained installer must be present to assess the failed areas and judge the cause and mode of failure prior to any fix or repairs being made. Installers shall make their best effort to repair any issues in a timely manner.

​

Warranty Conditions

This warranty applies to the material at its original place or installation. The warranty will be void if the materials are installed in violation of applicable local codes or ordinances, or if installed in a particular situation not intended for product use.

​

Warranty Exclusions

1. Abuse, alterations, damage due to animal chewing or clawing, cutting, chipping, accident, fire, corrosive liquids, extreme heat damage (over 250 degrees F), smoke damage, iron oxide penetration, hydrostatic water pressure.

2. Failure to properly prepare the substrate surface as per Reconstructed Surfaces instructions or advisories, or if products are installed or applied on top of, or mixed with other products not approved within the supplied instructions such as mixing Reconstructed Surfaces products with unapproved solvents or thinners, or applying Reconstructed Surfaces products over existing inferior paints or coatings, or otherwise using the products for other than their approved intended use. Proper concrete surface preparation by mechanical grinding includes removing all previous coatings, sealers, laitance, efflorescence, water repellents, curing compounds, oils, grease, waxes, and any other impediments to adhesion. The required surface profile must have a minimum 16 grit to 100 grit, a neutral pH of 7 and a moisture vapor transmission not to exceed 3 pounds (or 25lbs if a moisture vapor barrier was applied. Please refer to your quote for installed product strength). Reconstructed Surfaces is not responsible for determining if moisture transmission exists within the concrete substrate. Test can be performed upon request and will be charged for accordingly. Reconstructed Surfaces warranty liability will not exceed the cost of replacement materials.

​

How To Make A Claim

Promptly notify Reconstructed Surfaces at floors@reconstructedsurfaces.com, from whom the surface was installed and purchased, supply type of material, date of purchase and a description of the problem. A requirement of the warranty is that if you are attempting to make a claim you must
submit pictures of the alleged damage to the email above. Reconstructed Surfaces reserves the right at all times to inspect the claimed defective material and verify warranty coverage at its factory laboratory. This warranty shall be limited to replacement materials to the original purchaser of the product cost as determined by the amount of replacement materials required to repair or replace the defective product. The customer shall be responsible for the remainder of any costs of installation or product price increase over and above the original purchase price.

Any surface can be slippery, especially when wet with any fluid. In no event shall Reconstructed Surfaces be responsible for injury incurred by a slip or fall situation. It is the purchasers sole responsibility to provide for their own safety and the safety of their guests. While slip resistant additives assist slip/fall prevention, there is no guarantee that someone will not slip while walking on coated areas. Reconstructed Surfaces assumes no responsibility for slip-fall accidents.

​

Paid Repairs

Customers who have damage via cracks, crumbling or substrate failure are eligible to have their coatings repaired with a minimum service charge starting at $250. Damage the customer causes to their own floor are eligible to be repaired as well.

​

Miscellaneous

No one is authorized to make any other warranties on our behalf, ANY IMPLIED WARRANTIES, INCLUDING MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, SHALL NOT EXTEND BEYOND THE APPLICABLE WARRANTY PERIOD SPECIFIED ABOVE Reconstructed Surfaces. SOLE LIABILITY WITH RESPECT TO ANY DEFECT SHALL BE AS SET FORTH IN THIS WARRANTY AND ANY CLAIMS FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING DAMAGE FROM WATER LEAKAGE) ARE EXCLUDED.

Some states do not allow limitations on how long an implied warranty lasts, or for the exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. We suggest you print this certificate and complete the information on the reverse and retain this warranty certificate in the event this warranty information is needed. Reasonable proof of purchase and/or the effective date of the warranty must be presented and/or product batch numbers, otherwise the effective date will be based upon the date of the identified batch manufacture.